You want to set up demand sensing to analyze demand changes in execution or close to execution windows.
Which of the following conditions must you consider during the setup? Note: There are 2 correct Answers to this question.

• A.Set up the forecast model to be executed at product-location level.
• B.At setup test the system to run the demand sensing (full) algorithm weekly and the demand sensing (update) on a daily basis.
• C.It is mandatory to load historical lag-based snapshot data.
• D.The result generates sensed demand data at the monthly time granularity for the full time horizon

Comment: *

Name: *

Email: *

Verification: *

A time profile is defined with the levels of day, technical week, week, month, quarter, and year.
What condition in configuration will allow you to have a different value in the current week, versus all other buckets?

• A.IF("PERIODID5" ="$$PERIODID5CU$$...)
• B.IF("PERIODID3" ="$$PERIODID3CUSS...)
• C.IF("PERIODID4" = "SSPERIODID4CU$$...)
• D.IF("PERIODID2" ="$$PERIODID2CU$$...)

Comment: *

Name: *

Email: *

Verification: *

What type of key figure requires a planning level to have all attributes as roots?

• A.The conversion key figure, such as exchange rate
• B.The time independent key figure, such as FCSTMAPE
• C.The special key figure marked as an aggregate key figure
• D.The attribute transformation key figure, such as PERIODID1

Comment: *

Name: *

Email: *

Verification: *

When you promote calculated and approved inventory parameters from SAP IBP for inventory, what other IBP modules can be receiving them?
Note: There are 2 correct Answers to this question.

• A.SAP IBP for sales and operations
• B.SAP IBP for response and supply
• C.DDMRP
• D.SAP IBP for demand

Comment: *

Name: *

Email: *

Verification: *

Which of the following conditions are relevant for subtotals in the planning view? Note: There are 2 correct Answers to this question.

• A.The total value can be added before or after the selected attribute.
• B.The values of the attribute-based total at the highest attribute level in the planning level can be changed.
• C.Only attribute-based totals can be added to the planning view.
• D.The total number of attributes that can use subtotals in the planning view can be restricted.

Comment: *

Name: *

Email: *

Verification: *