Free SAP C-IBP-2211 Exam Dumps Questions & Answers

Which of the following are inputs to Demand Sensing with Gradient Boosting (Full) algorithm?Note: There are 2 correct answers to this question.

• A.  Sales Order Quantities (both historical and future open orders)
• B.  Future Consensus Forecasts and Lagged Forecast Snapshots
• C.  Forecast Error CV Calculated by Manage Forecast Error Calculations app
• D.  Recommended Safety Stocks from Multistage Inventory Optimization

What are some of the prerequisites for configuring a planning area that results in a successful consistency check?Note: There are 2 correct answers to this question.

• A.  Configure at least one calculated key figure for the planning area.
• B.  Configure at most two input key figures on the same planning level in a key figure calculation.
• C.  Specify a planning horizon in the planning area for each level of the assigned time profile.
• D.  Assign the compound master data type and its component master data types.

Which of the following are examples of time-independent key figures?Note: There are 2 correct answers to this question.

• A.  A unit of measure key figure, such as UOMCONVERSIONFACTOR
• B.  A special key figure marked as an aggregate key figure (aggregate constraint)
• C.  A currency conversion key figure, such as exchange rate
• D.  A forecast metric key figure, such FCSTMAPE

Which of the following solutions are feasible when using the time series supply optimizer?Note: There are 3 correct answers to this question.

• A.  Not respecting production capacity
• B.  Violation of minimum aggregated inventory values
• C.  Violation of minimum resource utilization
• D.  Not-fully satisfied demands
• E.  Not adhering to maximum transport values

Which of the following conditions are relevant for subtotals in the planning view?Note: There are 2 correct answers to this question.

• A.  The total value can be added before or after the selected attribute.
• B.  The values of the attribute-based total at the highest attribute level in the planning level can be changed.
• C.  Only attribute-based totals can be added to the planning view.
• D.  The total number of attributes that can use subtotals in the planning view can be restricted.