You need to use your resource cost effectively with a certain minimum use, even if it means producing more than demand. Which solutions would apply to this scenario? Note: There are 2 correct answers to this question.

• A.Minimum capacity utilization will result in pull production
• B.Balance can be achieved between excessive prebuild and minimum use by incorporating violation costs
• C.Capacity leveling will be possible for production and storage resources.
• D.Excess stock can be generated and will need to be staged in an overflow warehouse

Comment: *

Name: *

Email: *

Verification: *

Which of the following data can be tracked using a change-history-enabled key figure? Note: There are 3correct answers to this question

• A.Attributes
• B.Modified code
• C.Key figure type
• D.Scenario ID
• E.Reason code

Comment: *

Name: *

Email: *

Verification: *

What are some of the prerequisites for configuring a planning area that results in a successful consistency check? Note: There are 2 correct answers to this question.

• A.Configure at least one calculated key figure for the planning area
• B.Specify a planning horizon in the planning area for each level of the assigned time profile
• C.Assign the compound master data type and its component master data types
• D.Configure at most two input key figures on the same planning level in a key figure calculation

Comment: *

Name: *

Email: *

Verification: *

Which of the following conditions are relevant for subtotals in the planning view?Note: There are 2 correct answers to this question.

• A.The values of the attribute-based total at the highest attribute level in the planning level can be - changed
• B.The Total number of the attribute that can use subtotal in the planning view can be restricted
• C.The total value can be added before or after the selected attribute
• D.Only attribute-based totals can be added to the planning view.

Comment: *

Name: *

Email: *

Verification: *

You need to make manual adjustments to your S&OP plan. Which are possible ways of making these changes? Note: There are 2 correct answers to this question

• A.Leveraging the web-based Planning capability
• B.Using Microsoft Excel planning views
• C.Leveraging the functionality of SAP Work zone
• D.Using Driver-Based planning

Comment: *

Name: *

Email: *

Verification: *