A Solutions Architect is assisting a service provider with designing an NSX-T Data Center solution for these environments:
Virtual Data Center to Virtual Data Center connectivity
Tenant workload on-boarding to Virtual Data Centers.
These requirements must be met:
scalability across 5 data centers
all sites have a latency of 180ms
MTU between sites is 1800
bandwidth is 100Mbps between sites
multi-tenancy
Which two selections should the Solutions Architect propose to the service provider? (Choose two.)
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
Data between two networks connected over a public network needs to be encrypted.
Certificate authentication is required.
Dynamic route learning is preferred.
Which selection should the architect include in their design? (Choose the best answer.)
Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)
Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node?
(Choose two.)
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the Assessment Phase:
Maximum performance and availability is required between the physical and virtual network.
Load Balancing service is required for back-end web servers.
NAT is required.
Which selection should the architect include in their design? (Choose the best answer.)
