Company A has recently acquired Company B and needs to establish network connectivity. Company A has only Cisco for firewalls and VPN. Company B is using VMware SD-WAN.
Which VMware SD-WAN Cloud VPN solution should an administrator configure to establish connectivity?

• A.Branch to Non VMware SD-WAN Site.
• B.Branch to Main Office VPN
• C.Branch to SD-WAN Hub
• D.Branch to Branch VPN

Comment: *

Name: *

Email: *

Verification: *

A service provider wants to offer a common service from its data center via VMware SD-WAN Partner Gateway to many customers with overlapping IP addresses.
Which configuration must be implemented?

• A.Enable tag type QinQ under hand off interface configuration
• B.Enable NAT hand off under hand off static routes configuration
• C.Define multiple segments tor each customer
• D.Configure source policy-based NAT under business- policies configuration

Comment: *

Name: *

Email: *

Verification: *

A service provider assigns two Partner Gateways to a VMware SD-WAN Edge.
Which description is correct about default route.

• A.The service provider administrator decides whether the Partner Gateway advertises a default route
  0.0.0.0/0 or not, although it is advertised by default.
• B.A default route 0.0.0.0/0 can be configured as a static route and set to NAT only on the Gateway
• C.When handoff is turned off on a Partner Gateway, the Gateway does not advertise a default route 0.0
  0.0/0 to the Edge.
• D.It default route 0 0 0.010 has been configured for both Gateways, internet traffic originated from the Edge can failover to the other Gateway in case of a Gateway failure.

Comment: *

Name: *

Email: *

Verification: *

A customer is migrating a branch site with a VMware SD-WAN Edge coexisting with the CE. The Edge will be connected to internet link directly while connecting to the CE via a Layer 3 LAN switch.
MPLS underlay is the preferred path for communication from this site to branch sites that have no VMware SD-WAN Edges. Communication from this site to branch sites that have VMware SD-WAN Edges should go through overlay.

• A.Use BGP as the routine, protocol on the Edge and flag its BGP neighbor to GE as Uplink.
• B.Use BGP as the rout.ng protocol on UK Edge and flag its BGP neighbor to the Layer 3 LAN switch as Uplink.
• C.Use BGP as the routing protocol on the Edge and flag its HGP neighbor to PE as Uplink.
• D.Use BGP as the routing protocol on the Edge and filter prefixes from CE using Uplink Community

Comment: *

Name: *

Email: *

Verification: *

A network architect is designing a VMware SD-WAN architect for customer using VMware hosted VCO and VCGs, white VCEs will be deployed at the customer's branches and data centers. The network architect would like to achieve control plane redundancy.
Which action, if any, should be taken to meet this goal?

• A.VCGs automatically assigned to a VCF. do not participate in control plane At least two dedicated Controllers should be manually assigned for each VCGs to achieve control plane redundancy.
• B.Multiple VCGs are automatically assigned to every VCE and control plane on VCUs is always enabled, so control plane redundancy has been taken care of already
• C.VCGs automatically assigned to a VCE do not participate in control plane At least two dedicated Controllers should be manually assigned for the customer to achieve control plane redundancy
• D.Multiple VCFs at data centers can becontoured to function as route reflectors to achieve control plane redundancy.

Comment: *

Name: *

Email: *

Verification: *