At the discretion of ________, on-stream inspection may be substituted for internal inspection.

• A.An engineer experienced in pressure vessel design
• B.The owner-user of the pressure vessel
• C.An engineer experienced in corrosion
• D.The authorized pressure vessel inspector

Comment: *

Name: *

Email: *

Verification: *

Discuss how API-510 influences the design phase of pressure vessels to ensure compliance from the initial stages.

Comment: *

Name: *

Email: *

Verification: *

How does API-510 address the challenges of inspecting pressure vessels in remote or hazardous locations?

Comment: *

Name: *

Email: *

Verification: *

What is the minimum temperature of the metal during a pressure test of a 2.125" thick vessel?

• A.Minimum temperature shall be 60°F
• B.Minimum temperature shall be ambient temperature but not less than 55°F
• C.Minimum temperature shall be at least 30˚F above the minimum design metal temperature
• D.Minimum temperature shall be at least 20˚F above the minimum design metal temperature

Comment: *

Name: *

Email: *

Verification: *

Which of the following will vessel rerating involve:

• A.Review Inspection records verify the pressure vessel has been in the proposed service previously
• B.Calculations from only a manufacturer experienced in pressure vessels
• C.Calculations from either the manufacturer or an owner-user engineer experienced in pressure vessels
• D.Use of Non-Code requirements as established in accordance with the alternative rules of API 572

Comment: *

Name: *

Email: *

Verification: *