How do you configure an alert in SmartView Monitor?

• A.An alert cannot be configured in SmartView Monitor.
• B.By right-clicking on the Gateway, and selecting Properties.
• C.By choosing the Gateway, and Configure Thresholds.
• D.By right-clicking on the Gateway, and selecting System Information.

Comment: *

Name: *

Email: *

Verification: *

When should you generate new licenses?

• A.After an RMA procedure when the MAC address or serial number of the appliance changes.
• B.Only when the license is upgraded.
• C.Before installing contract files.
• D.When the existing license expires, license is upgraded or the IP-address where the license is tied changes.

Comment: *

Name: *

Email: *

Verification: *

What Check Point technologies deny or permit network traffic?

• A.ACL, SandBlast, MPT
• B.IPS, Mobile Threat Protection
• C.Packet Filtering, Stateful Inspection, Application Layer Firewall.
• D.Application Control, DLP

Comment: *

Name: *

Email: *

Verification: *

What object type would you use to grant network access to an LDAP user group?

• A.SmartDirectory Group
• B.Access Role
• C.User Group
• D.Group Template

Comment: *

Name: *

Email: *

Verification: *

You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don't have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?

• A.fw ctl multik dynamic_dispatching set_mode 9
• B.fw ctl miltik pq enable
• C.fw ctl multik dynamic_dispatching on
• D.fw ctl multik set_mode 9

Comment: *

Name: *

Email: *

Verification: *