Which path below is available only when CoreXL is enabled?

• A.Slow path
• B.Medium path
• C.Firewall path
• D.Accelerated path

Comment: *

Name: *

Email: *

Verification: *

As you review this Security Policy, what changes could you make to accommodate Rule 4?

• A.Modify the column VPN in Rule 2 to limit access to specific traffic.
• B.Nothing at all
• C.Remove the service HTTP from the column Service in Rule 4.
• D.Modify the columns Source or Destination in Rule 4

Comment: *

Name: *

Email: *

Verification: *

When configuring Spoof Tracking, which tracking actions can an administrator select to be done when spoofed packets are detected?

• A.Log, send snmp trap, email
• B.Drop packet, alert, none
• C.Log, alert, none
• D.Log, allow packets, email

Comment: *

Name: *

Email: *

Verification: *

Sticky Decision Function (SDF) is required to prevent which of the following? Assume you set up an Active-Active cluster.

• A.Asymmetric routing
• B.Symmetric routing
• C.Anti-Spoofing
• D.Failovers

Comment: *

Name: *

Email: *

Verification: *

After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.

• A.add interface Mgmt ipv4-address 192.168.80.200 255.255.255.0add static-route 0.0.0.0.0.0.0.0 gw 192.168.80.1 onsave config
• B.set interface Mgmt ipv4-address 192.168.80.200 255.255.255.0add static-route 0.0.0.0.0.0.0.0 gw 192.168.80.1 onsave config
• C.add interface Mgmt ipv4-address 192.168.80.200 mask-length 24add static-route default nexthop gateway address 192.168.80.1 onsave config
• D.set interface Mgmt ipv4-address 192.168.80.200 mask-length 24set static-route default nexthop gateway address 192.168.80.1 onsave config

Comment: *

Name: *

Email: *

Verification: *