Refer to the exhibit.

An engineer is configuring an EtherChannel using LACP between Switches 1 and 2 Which configuration must be applied so that only Switch 1 sends LACP initiation packets?

• A.Switch 1 (config-if)#channel-group 1 mode on
  Swrtch2(config-if)#channel-group 1 mode passive
• B.Switch1(config-if)#channel-group 1 mode on
  Switch2(config-if)#channel-group 1 mode active
• C.Switch1(config-if)#channel-group 1 mode passive
  Switch2(config-if)#channel-group 1 mode active
• D.Switch1{config-if)#channel-group 1 mode active
  Switch2(config-if)#channel-group 1 mode passive

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1 The new circuit uses eBGP and teams the route to VLAN25 from the BGP path What s the expected behavior for the traffic flow for route 10.10.13.0/25?

• A.Traffic to 10.10.13.0.25 is load balanced out of multiple interfaces
• B.Traffic to 10.10.13.0/25 is asymmeteical
• C.Route 10.10.13.0/25 is updated in the routing table as being learned from interface Gi0/1.
• D.Route 10.10.13.0/25 learned via the GiO/0 interface remains in the routing table

Comment: *

Name: *

Email: *

Verification: *

Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?

• A.transport
• B.network
• C.session
• D.application
• E.presentation

Comment: *

Name: *

Email: *

Verification: *

In which circumstance would a network architect decide to implement a global unicast subnet instead of a unique local unicast subnet?

• A.when the subnet must be available only within an organization
• B.when the addresses on the subnet must be equivalent to private IPv4 addresses
• C.when the subnet must be routable over the internet
• D.when the subnet does not need to be routable

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A new VLAN and switch are added to the network. A remote engineer configures OldSwitch and must ensure that the configuration meets these requirements:
* accommodates current configured VLANs
* expands the range to include VLAN 20
* allows for IEEE standard support for virtual LANs
Which configuration on the NewSwitch side of the link meets these requirements?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *