Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable What is the result of this configuration?

• A.The link is in a downstate.
• B.The link is in an error disables state
• C.The link is becomes an access port.
• D.The link becomes a trunkport.

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

What is the same for both copper and fiber interfaces when using SFP modules?

• A.They accommodate single-mode and multi-mode in a single module
• B.They support an inline optical attenuator to enhance signal strength
• C.They provide minimal interruption to services by being hot-swappable
• D.They offer reliable bandwidth up to 100 Mbps in half duplex mode

Comment: *

Name: *

Email: *

Verification: *

An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?

• A.Exchange
• B.Full
• C.2-way
• D.Init

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer is in the process of establishing IP connectivity between two sites. Routers R1 and R2 are partially configured with IP addressing. Both routers have the ability to access devices on their respective LANs. Which command set configures the IP connectivity between devices located on both LANs in each site?

• A.Option C
• B.Option A
• C.Option B
• D.Option D

Comment: *

Name: *

Email: *

Verification: *