Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

• A.Use a prefix list instead of an access list in the route map.
• B.Use an extended access list instead of a standard access list.
• C.Add this statement to the route map: route-map RM-OSPF-DL deny 20.
• D.Change sequence 10 in the route-map command from permit to deny.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network administrator configured mutual redistribution on R1 and R2 routers, which caused instability in the network. Which action resolves the issue?

• A.Advertise summary routes of EIGRP to OSPF and deny specific EIGRP routes when redistributing into OSPF.
• B.Apply a prefix list of EIGRP network routes in OSPF domain on R1 to propagate back into the EIGRP routing domain.
• C.Set a tag in the route map when redistributing EIGRP into OSPF on R1. and match the same tag on R2 to deny when redistributing OSPF into EIGRP.
• D.Set a tag in the route map when redistributing EIGRP into OSPF on R1. and match the same tag on R2 to allow when redistributing OSPF into EIGRP.

Comment: *

Name: *

Email: *

Verification: *

Refer to Exhibit.

Traffic from the branch network should route through HQ R1 unless the path is unavailable. An engineer tests this functionality by shutting down interface on the BRANCH router toward HQ_R1 router but 192.168.20.0/24 is no longer reachable from the branch router. Which set of configurations resolves the issue?

• A.HQ_R1(config)# ip sla responder
  HQ_R1(config)# ip sla responder icmp-echo 172.16.35.2
• B.BRANCH(config)# ip sla 1
  BRANCH(config-ip-sla)# icmp-echo 172.16.35.1
• C.HQ_R2(config)# ip sla responder
  HQ_R2(config)# ip sla responder icmp-echo 172.16.35.5
• D.BRANCH(config)# ip sla 1
  BRANCH(config-ip-sla)# icmp-echo 172.16.35.2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?
A)

B)

C)

D)

• A.Option D
• B.Option A
• C.Option C
• D.Option B

Comment: *

Name: *

Email: *

Verification: *

Which security feature can protect DMVPN tunnels?

• A.TACACS+
• B.RADIUS
• C.RTBH
• D.IPsec

Comment: *

Name: *

Email: *

Verification: *