Which statement about IPv6 ND inspection is true?

• A.It learns and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables.
• B.It learns and secures bindings for stateless autoconfiguration addresses in Layer 2 neighbor tables.
• C.It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables.
• D.It learns and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Users report that IP addresses cannot be acquired from the DHCP server. The DHCP server is configured as shown. About 300 total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day. Which action fixes the issue within the current resources?

• A.Configure the DHCP lease time to a smaller value
• B.Add the network 192.168.2.0 255.255.255.0 command to the DHCP pool
• C.Configure the DHCP lease time to a bigger value
• D.Modify the subnet mask to the network 192.168.1.0 255.255.254.0 command in the DHCP pool

Comment: *

Name: *

Email: *

Verification: *

An engineer is implementing a coordinated change with a server team. As part of the change, the engineer must configure interlace GigabitEthernet2 in an existing VRF "RED" then move the interface to an existing VRF "BLUE" when the server team is ready. The engineer configured interface GigabitEthemet2 in VRF
"RED"

Which configuration completes the change?

• A.interface GigabitEthernet2
  no ip address
  vrf forwarding BLUE
• B.interface GigabitEthernet2
  no vrf forwarding RED
  vrf forwarding BLUE
  ip address 10.0.0.0 255.255.255.254
• C.interface GigabitEthernet2
  no vrf forwarding RED
  vrf forwarding BLUE
• D.interface GigabitEthernet2
  no ip address
  ip address 10.0.0.0 255.255.255.254
  vrf forwarding BLUE

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.

Correct Answer:

Reference:
https://www.rogerperkin.co.uk/featured/route-distinguisher-vs-route-target/

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the summary route does not show up in the routing table. Why is the summary route missing?

• A.The summary-address command is used only for summarizing prefixes between areas.
• B.The summary route is visible only in the OSPF database, not in the routing table.
• C.There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.
• D.The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.

Comment: *

Name: *

Email: *

Verification: *