Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.

Correct Answer:

Explanation
Same Answer is already updated below:

HTTP and HTTPs run on TCP port 80 and 443, respectively and we have to remember them.
Syslog runs on UDP port 514 while NTP runs on UDP port 123 so if we remember them we can find out the matching answers easily. But maybe there is some typos in this question as 2001:d88:800:200c::c/126 only ranges from 2001:d88:800:200c:0:0:0:c (4 hosts in total). It does not cover host 2001:0D88:0800:200c::1f. Same for , which also ranges from
2001:d88:800:200c:0:0:0:c to 2001:d88:800:200c:0:0:0:f and does not cover host 2001:0D88:0800:200c::1c
.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

AS111 is receiving its own routes from AS200 causing a loop in the network. Which configuration provides loop prevention?
A)

B)

C)

D)

• A.Option D
• B.Option B
• C.Option A
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A client is concerned that passwords are visible when running this show archive log config all.
Which router configuration is needed to resolve this issue?

• A.MASS-RTR(config-archive-log-cfg)#password encryption aes
• B.MASS-RTR(config)#aaa authentication arap
• C.MASS-RTR(config)#service password-encryption
• D.MASS-RTR(config-archive-log-cfg)#hidekeys

Correct Answer: D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer applied a filter for LSA traffic on OSPFv3 interarea routes on the area 5 ABR to protect advertising the internal routes of area 5 to the business partner network. All other areas should receive the area 5 internal routes. After the respective route filtering configuration is applied on the ABR, area 5 routes are not visible on any of the areas. How must the filter list be applied on the ABR to resolve this issue?

• A.in the "in" direction for area 5 on router R1
• B.in the "out" direction for area 5 on router R1
• C.in the "in" direction for area 20 on router R2
• D.in the "out" direction for area 20 on router R2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

• A.Start IP SLA by defining frequency and scheduling it
• B.Start IP SLA by matching numbers for track and ip sla commands
• C.Use the same AD for both default routes
• D.Use the icmp-echo command to track both default routes

Comment: *

Name: *

Email: *

Verification: *