Refer to the exhibit.
Refer to the exhibit. Router R1 peers with two ISPs using static routes to get to the internet. The requirement is that R1 must prefer ISP-A under normal circumstances and failover to ISP-B if the connectivity to ISP-A is lost. The engineer observes that R1 is load balancing traffic across the two ISPs Which action resolves the issue by sending traffic to ISP-A only with failover to ISP-B?
Clients on ALS2 receive IPv4 and IPv6 addresses but clients on ALS1 receive only IPv4 addresses and not IPv6 addresses. Which action on DSW1 allows clients on ALS1 to receive IPv6 addresses?
A) Configure DSW1(config-if)#ipv6 helper address 2002:404:404::404:404
B) Configure DSW1(dhcp-config)#default-router 2002:A04:A01::A04:A01
C) Configure DSW1(config)#ipv6 route 2002:404:404:404:404/128 FastEthernet1/0 D) Configure DSW1(config-if)#ipv6 dhcp relay destination 2002:404:404::404:404 GigabitEthernet1/2
Drag and drop the MPLS terms from the left onto the correct definitions on the right.
Which two solutions are used to overcome a flapping link that causes a frequent label binding exchange between MPLS routers? (Choose two)
Refer to the exhibit.
A router receiving BGP routing updates from multiple neighbors for routers in AS 690. What is the reason that the router still sends traffic that is destined to AS 690 to a neighbor other than 10.222.1.1?
