Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

• A.Option A
• B.Option B
• C.Option C
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.


A network administrator sets up an OSPF routing protocol for a DMVPN network on the hub router. Which configuration required to establish a DMVPN tunnel with multiple spokes?

• A.ip ospf network point-to-point on the hub router
• B.ip ospf network point-to-multipoint on both spoke routers
• C.ip ospf network point-to-multipoint on One spoke router
• D.ip ospf network point-to-point on both spoke routers

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from the help desk that branch personnel cannot reach any network destinations. Which configuration restores service and continues to block 10.1.1.100/32?

• A.route-map FILTER-IN deny 5
• B.ip prefix-list 102 seq 15 permit 0.0.0.0/32 le 32
• C.ip prefix-list 102 seq 5 permit 0.0.0.0/32 le 32
• D.route-map FILTER-IN permit 20

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from the help desk that branch personnel cannot reach any network destinations. Which configuration restores service and continues to block 10.1.1.100/32?

• A.route-map FILTER-IN deny 5
• B.ip prefix-list 102 seq 15 permit 0.0.0.0/32 le 32
• C.ip prefix-list 102 seq 5 permit 0.0.0.0/32 le 32
• D.route-map FILTER-IN permit 20

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

• A.Use the icmp-echo command to track both default routes
• B.Start IP SLA by matching numbers for track and ip sla commands
• C.Use the same AD for both default routes
• D.Start IP SLA by defining frequency and scheduling it

Comment: *

Name: *

Email: *

Verification: *