Refer to the exhibit.

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?

• A.Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
• B.Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
• C.Set the administrative distance 100 under the RIP process on R2.
• D.Redistribute the directly connected interfaces on R2.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. An administrator must upload the packages conf Me to an FTP server. However, the FTP server rejected anonymous service and required users to authenticate What are the two ways to resolve the issue? (Choose two.)

• A.Use the copy flash-packages conf ftp: command instead and enter the FTP server credent-ais when prompted.
• B.Create a user on the rooter matching the username and password on the FTP server and log in before attempting the copy
• C.Use the copy flash:packages.conf scp: command instead and enter the FTP server credentials when prompted.
• D.Use is ftp username and ip ftp password configuration commands to specify valid FTP server credentials.
• E.Enter the FTP server credentials directly In the FTP URL using the ftp://username:passwordQ192.0.2.40/ syntax .

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the actions from the left into the correct order on the right to configure a policy to avoid following packet forwarding based on the normal routing path.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

BGP is flapping after the Copp policy is applied. What are the two solutions to fix the issue?
(Choose two)

• A.Configure BGP in the COPP-CRITICAL-7600 ACL
• B.Configure a higher value for CIR under the default class to allow more packets during peak traffic
• C.Configure a higher value for CIR under the class COPP-CRITICAL-7600
• D.Configure a three-color policer instead of two-color policer under class COPP-CRITICAL-
  7600
• E.Configure IP CEF to CoPP policy and BGP to work

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The ACL is placed on the inbound Gigabit 0/1 interface of the router. Host
192.168.10.10cannot SSH to host 192.168.100.10 even though the flow is permitted. Which action resolves the issue without opening full access to this router?

• A.Temporarily remove the ACL from the interface to see if the flow works
• B.Run the show access-list FILTER command to view if the SSH entry has any hit statistic associated with it
• C.Move the SSH entry to the beginning of the ACL
• D.Temporarily move the permit ip any any line to the beginning of the ACL to see if the flow works

Comment: *

Name: *

Email: *

Verification: *