A customer called with a requirement that internal clients must be on different subnets depending on the building they are in All access points are operating in local mode and will not be modified, and this is a single controller solution Which design approach creates the desired result?

• A.Create AP groups for each desired location, map the correct VLANs to the internal SSlD and add the access prints for that location
• B.Create mobility anchors for the SSID. and on the controller under the internal SSID. create a foreign map to the desired VLAN based on location
• C.Create FiexConnect groups, place the access points in. and set the correct VLAN to SSlD mapping based on location.
• D.Create an SSID. place it to the desired VLAN under WLANs. and configure 802.ix in ISE to assign the correct VLAN based on the SSlD from which the client is authenticating.

Comment: *

Name: *

Email: *

Verification: *

A university is in the process of designing a wireless network in an auditorium that seats 500 students and supports student laptops. Which design methodology should the university implement in the auditorium?

• A.roaming design model
• B.voice design model
• C.location design model
• D.high-density design model

Comment: *

Name: *

Email: *

Verification: *

Which statement about the 9800 Series Wireless Controller mobility tunnel on a Cisco Catalyst 9800 controller is true?

• A.It is an IPsec tunnel with control path only.
• B.It is a CAPWAP tunnel with data path only.
• C.It is a CAPWAP tunnel with control path and data path.
• D.It is an IPsec tunnel with control path and data path.

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

A wireless engineer is performing a post verification of a wireless network. Which two metrics does the engineer verify to ensure that the wireless network can support voice services? (Choose two.)

• A.The coverage area must have a noise floor that does not exceed -87 dBm.
• B.The client device must have at least an -67 dBm RSSI.
• C.The rate of retransmitted packets must be 15 percent or below.
• D.The rate of retransmitted packets must be 20 percent or below.
• E.The client device must have at least an -65 dBm RSSI.

Correct Answer: B,D

Comment: *

Name: *

Email: *

Verification: *

A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern?

• A.Use enclosures to hide the wireless infrastructure in the surrounding environment.
• B.Use AIR-AP-BRACKET-1 to allow for greater mounting locations
• C.Deploy environmentally friendly cabling components to blend into the environment.
• D.Paint the access point to cover the LED from being noticeable.

Comment: *

Name: *

Email: *

Verification: *