A network engineer is configuring high availability on an access point. What is the maximum number of controllers that can be configured?

• A.1
• B.2
• C.3
• D.4

Correct Answer: B

Explanation

So max 2 will be supported on an AP.

Comment: *

Name: *

Email: *

Verification: *

Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

• A.When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
• B.When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
• C.When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
• D.When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Correct Answer: B

Comment: *

Name: *

Email: *

Verification: *

A wireless engineer is utilizing the voice readiness tool in Cisco Prime for a customer that wants to deploy Cisco IP phones. Which dBm range is the network inspected against?

• A.-78 to -65 dBm
• B.-72 to -67 dBm
• C.-85 to -65 dBm
• D.-85 to -67 dBm

Comment: *

Name: *

Email: *

Verification: *

What causes the most signal attenuation, based on the wireless design tools?

• A.cinder block wall
• B.metal door
• C.glass wall
• D.office window

Correct Answer: B

Comment: *

Name: *

Email: *

Verification: *

A high-density wireless network is designed. Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?

• A.Band Select
• B.RRM
• C.Cisco Centralized Key Management
• D.load balancing

Correct Answer: A

Comment: *

Name: *

Email: *

Verification: *