Refer to the exhibit. Which duplicate configuration causes this message during setup of an MPLS BGP network?

• A.ASNs
• B.originator ID
• C.router ID
• D.cluster ID

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?

• A.Option A
• B.Option B
• C.Option C
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Routers R1 and R2 reside in AS 65530, which is multihomed to the Internet.
A network engineer expects devices in the AS to use R2 to access the Internet, but they are using R1 as the exit point from the AS. Which action corrects the problem?

• A.Add a sequence number to the route map to remove the implicit deny.
• B.Change the route map direction in the neighbor statement to out.
• C.Configure the route map with a local preference of 200 or higher.
• D.Remove the neighbor statements from the address family configuration and activate the neighbor globally on R1.

Comment: *

Name: *

Email: *

Verification: *

What is one of the purposes of a default Multicast Distribution Tree?

• A.to define the RP for PIM sparse mode and the different leafs
• B.to handle high-bandwidth source streams
• C.to support control traffic between different VRFs
• D.to offload traffic from data MDT

Comment: *

Name: *

Email: *

Verification: *

A network engineer is troubleshooting OSPF multiare
a. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

• A.DR support for topology management
• B.show lp ospf topology command
• C.hierarchical CLI
• D.routing process enabled by default on all interfaces

Comment: *

Name: *

Email: *

Verification: *