Refer to the exhibit. A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired.
Where should the soft preemption be applied to solve the issue?

• A.Under the interface Loopback0 necessary for this deployment type.
• B.explicitly for tunnel-te 1 under the Cisco MPLS TE configuration mode after the timeout setting
• C.on the tail-end device for tunnel-te1 192.168.0.7
• D.under the tunnel-te1 interface on PE1

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?

• A.The MED attribute can be applied on R2 to influence R1 to use it as the primary path.
• B.The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.
• C.The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.
• D.The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.

Comment: *

Name: *

Email: *

Verification: *

What is determined by running the same hash algorithm on all PIMv2 routers?

• A.Auto RP election
• B.Which RP to use from a set of candidate RPs in the RP set
• C.The SPT from the last hop router to the multicast source
• D.The SPT from the RP to the multicast source
• E.Which BSR to use for a particular multicast group

Comment: *

Name: *

Email: *

Verification: *

An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network. Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are used.)

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which two commands must the engineer configure for the company's PIM-PIM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface without affecting normal operation? (Choose two)

• A.enable auto-rp listener
• B.enable dense mode
• C.enable sparse-mode
• D.enable Auto-RP announcements
• E.enable sparse-dense mode

Comment: *

Name: *

Email: *

Verification: *