Which cost is the default when redistributing routes from BGP to OSPF?

• A.20
• B.1
• C.infinite
• D.automatic

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network operator is getting the route for 10.11.11 0/24 from two upstream providers on
#XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of
10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?

• A.weight of 0 on the prefix coming from 192.168.0.2
• B.lower local preference on the prefix coming from 192.168.0.2
• C.higher local preference on the prefix coming from 192.168.0.1
• D.weight of 100 on the prefix coming from 192.168.0.1

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied.
The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other.
Which two actions fix the issue? (Choose two.)

• A.Change MD5 to HMAC-SHA1-12
• B.Change MD5 to HMAC-ESP
• C.Change MD5 to SHA-1
• D.Change MD5 to HMAC-MD5
• E.Remove the send and accept lifetime under key 1

Comment: *

Name: *

Email: *

Verification: *

What are the two characteristics of route reflectors? (Choose two.)

• A.Routes received from nonclient peers are reflected to route reflector clients as well as nonclient peers.
• B.If a router received an iBGP route with the originator-ID attribute set to its owm router ID, the route is discarded.
• C.Routes received from a route reflector Client are reflected to other clients and nonclient peers.
• D.If a route reflector receives a route with a cluster-list attribute containing a different cluster ID, the route is discarded.
• E.Routes received from nonclient peers are reflected to route renector cluster as well as OSPF peers.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed.
Which statement about this configuration is true?

• A.Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
• B.Router 1 must define an explicit path to router 2
• C.Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
• D.Router 2 must have a tunnel interface created with router 1 as the destination

Comment: *

Name: *

Email: *

Verification: *