What is the difference between RPL and route map actions?

• A.RPL uses pass, set. drop, and done actions, and route maps use match and set actions only.
• B.RPL uses match, set, drop, and stop actions, and route maps use match, set, and drop actions.
• C.RPL uses match, pass, set, and drop actions, and route maps use match, set. and drop actions.
• D.RPL uses pass. set. and drop actions only, and route maps use match, set, and drop actions.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which tree does multicast traffic follow?

• A.MDT default
• B.MDT voice
• C.source tree
• D.shared tree

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer commissioned Router 1, which connects lo Router 2 and Router 5 Router 1 participates in IS-IS routing with other routers, but it is not used for transit traffic. Traffic from Router 2 to Router 5 is expected to travel via Router 1 but the traffic is travelog via Router 3 and Router 4 Which action reserves this problem?

• A.Add the overload bit on Router 5
• B.Remove the overload bit on Router 1.
• C.Add hello padding on Router 1
• D.Remove the hello padding on Router 5

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Mid-sized company Z connected two branch offices via a multicast-enabled ISP using the BGP routing protocol. PIM was implemented to support multicast streaming between the branches via MSDP. Client A cannot connect to the multicast stream source of company Z. The network engineer ran a debug on the edge of the network as shown.
Which action resolves the issue?

• A.Deploy BSR on routers R1 and R2 and enable multicast on both LAN segments.
• B.Configure the PIM protocol on the Serial 1/1 interface and enable Auto-RP.
• C.Implement MBGP and enable a multicast address family on R2.
• D.Enable the BGP routing protocol and advertise the 10 10.10.0/24 subnet on R1.

Comment: *

Name: *

Email: *

Verification: *

Which statement about BFD on Cisco IOS XR Software is true?

• A.Cisco IOS XR router must use LDP to route back to the Cisco IOS router to establish the peer relationship.
• B.Cisco IOS XR Software does not support BFD multihop for IPv4.
• C.Cisco IOS XR router must use dynamic routing or a static route back to the Cisco IOS router to establish the peer relationship.
• D.BFD is not compatible between Cisco IOS XR and Cisco IOS Software.

Comment: *

Name: *

Email: *

Verification: *