Refer to the exhibit. How are packets directed through the data plane when SRv6 is implemented?

• A.An ordered list of segments is encoded in a routing extension header
• B.The MPLS data plane is used to push labels onto IGP routes
• C.A stack of labels represents an ordered list of segments
• D.The packet is encapsulated with a header and trailer encoding the ordered list of segments

Comment: *

Name: *

Email: *

Verification: *

Level 3 switch SW1 is part of an EIGRP enabled network located at the edge of an are a. Cisco Express Forwarding and SSO are enabled on the router. A network engineer must minimize the downtime of data-transmit services in the network. HSRP group 2 has already been configured with standby preempt delay minimum 2 and standby timers 140. Which additional action must the engineer take on SW1 to suppress routing flaps for 2 minutes?

• A.Configure timers standby 2 wait 2 under the HSRP group 2 configuration.
• B.Configure timers nsf route-hold 120 under the global EIGRP configuration.
• C.Configure timers standby 2 coverage 120 under the HSRP group 2 configuration.
• D.Configure timers nsf signal 2 under the global EIGRP IPv4 address family.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which statement about this configuration is true?

• A.Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
• B.Router 1 receives only the best path from neighbor 192.168.1.1
• C.Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
• D.Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which effect of this configuration is true?

• A.It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds
• B.It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds
• C.It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds
• D.It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.

Comment: *

Name: *

Email: *

Verification: *