Refer to the exhibit.

How are packets directed through the data plane when SRv6 is implemented?

• A.A stack of labels represents an ordered list of segments
• B.The MPLS data plane is used to push labels onto IGP routes
• C.The packet is encapsulated with a header and trailer encoding the ordered list of segments
• D.An ordered list of segments is encoded in a routing extension header

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the relationship between Router 1 and Router 2?

• A.Router 2 is the head-end router in an SR-TE tunnel, and it is learning topology of the network from the PCE enabled on Router 1.
• B.Router 1 and Router 2 centrally learn the topology of the network to aid in SR-TE path selection for peers.
• C.Router 1 and Router 2 are participating in SR-TE tunnels and are both head-end routers.
• D.Router 1 centrally learns the topology of the network to aid in SR-TE path selection, and Router 2 is a node that feeds Router 1 topology information.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

After these configurations were applied to routers R1 and R2. the two devices cannot form a neighbor relationship What is the reason tor the problem?

• A.The two routers have the same network ID
• B.The two routers have different iS-types
• C.The two routers cannot authenticate with one another
• D.The two routers have the same area ID.

Comment: *

Name: *

Email: *

Verification: *

What is the purpose of the confederation identifier in a BGP confederation?

• A.It advertises routes outside of the confederation's autonomous system.
• B.It reflects the route reflector duster ID within the confederation.
• C.It identifies the autonomous system that belongs to the confederation.
• D.It carries the AS number within the confederation s local autonomous system

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit After recent configuration changes to a customer's network, a network engineer notices that R2 cannot communicate with R3 Both FastEthemet interfaces on R2 and R3 are up and configured with the correct IP addresses MD5 password configured en R2 and R3 match with no issues What is the minimum change the engineer must make to enable R2 and R3 to communicate and fix the problem?

• A.Configure interface F0/0 on RI and R2 to be in area O.
• B.Configure virtual links between RI and R3.
• C.Define area 2 as a NSSA on R2 and R3
• D.Configure a loopback interface on R2 and assign it to area 0.

Comment: *

Name: *

Email: *

Verification: *