Refer to the exhibit. While provisioning a new BGP session between the PE and CE router, you issue the as-override command. Which statement describes modification of the prefix before being sent to the CE router (10.10.10.1)?

• A.The first and fourth autonomous systems change.
• B.The fourth AS changes, but no other autonomous systems change.
• C.The first AS changes, but no other autonomous systems change.
• D.The second and third autonomous systems change.

Comment: *

Name: *

Email: *

Verification: *

Which two are characteristics of using a non-MPLS peer-to-peer model over a traditional overlay model? (Choose two.)

• A.The model is suited for nonredundant configurations.
• B.The configuration on a newly added site PE is updated automatically.
• C.Provider routers know the customer network topology.
• D.The customer specifies the exact site-to-site traffic profile.
• E.Routing information is exchanged between the customer router and one or a few PEs.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration?
(Choose two.)

• A.Only the CE2 VRF can access the default route provided by the Internet VRF.
• B.All three routers must be running a distance-vector routing protocol.
• C.The CE1 and CE2 VRFs can exchange routes only between their respective VRFs on PE1 and PE2.
• D.All three routers must be running MP-BGP.
• E.The CE1 and CE2 VRFs can access the default route provided by the Internet VRF.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?

• A.A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.
• B.The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.
• C.The MAC address is entered into the CAM table and is classified for use on the native VLAN
• D.The MAC address is entered into the CAM table only if it is learned on the native VLAN.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit Router 1 is a P router in the ISP MPLS core A connected P router cannot generate an MPLS label for the router 1 loopback0 interface Which action resolves this issue?

• A.The loopback0 interface must be in OSPF area 0.
• B.The OSPF network type must be changed on loopback0 to point-to-point
• C.The network statement under the routing process must have a wildcard mask of 0 0.0 255.
• D.A static route to null 0 must be added for the loopback interface and then static routes must be redistributed into OSPF

Comment: *

Name: *

Email: *

Verification: *