Refer to the exhibit.

Which IPv6 OSPF network type is applied to interface Fa0/0 of R2
by default?

• A.multipoint
• B.broadcast
• C.Ethernet
• D.point-to-point

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?

• A.Increase the NAT pool size to support 254 usable addresses
• B.Configure a match-host type NAT pool
• C.Configure a one-to-one type NAT pool
• D.Reconfigure the pool to use the 192.168 1 0 address range

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet
0/1. Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)

B)

C)

D)

• A.Option C
• B.Option A
• C.Option B
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Which method displays text directly into the active console with a synchronous EEM applet policy?

• A.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 gets 'logging directly to console'
• B.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 syslog priority direct msg 'log directly to console'
• C.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 puts 'logging directly to console'
• D.event manager applet boom
  event syslog pattern 'UP'
  action 1.0 string 'logging directly to console'

Correct Answer: B

Explanation
To enable the action of printing data directly to the local tty when an Embedded Event Manager (EEM) applet is triggered, use the action puts command in applet configuration mode.
The following example shows how to print data directly to the local tty:

The action puts command applies to synchronous events. The output of this command for a synchronous applet is directly displayed to the tty, bypassing the syslog.
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/eem/command/eem-cr-book/eemcr- a1.html

Comment: *

Name: *

Email: *

Verification: *

Which method creates an EEM applet policy that is registered with EEM and runs on demand or manually?

• A.event manager applet ondemand
  event register
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• B.event manager applet ondemand
  event manual
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• C.event manager applet ondemand
  event none
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• D.event manager applet ondemand
  action 1.0 syslog priority critical msg 'This is a message from ondemand'

Comment: *

Name: *

Email: *

Verification: *