Refer to the exhibit.

A network engineer is configuring OSPF between router R1 and router R2. The engineer must ensure that a DR/BDR election does not occur on the Gigabit Ethernet interfaces in area 0. Which configuration set accomplishes this goal?
A)

B)

C)

D)

• A.Option A
• B.Option B
• C.Option C
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem?

• A.The port-channel should be set to auto.
• B.The port-channel interface lead balance should be set to src-mac
• C.The port channel on SW2 is using an incompatible protocol.
• D.The port-channel trunk is not allowing the native VLAN.

Comment: *

Name: *

Email: *

Verification: *

Which statement about an RSPAN session configuration is true?

• A.A special VLAN type must be used as the RSPAN destination.
• B.Only one session can be configured at a time
• C.Only incoming traffic can be monitored
• D.A fitter mutt be configured for RSPAN Regions

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which command must be applied to R2 for an OSPF neighborship to form?

• A.network 20.1.1.2.0.0.0.0 area 0
• B.network 20.1.1.2 255.255.0.0. area 0
• C.network 20.1.1.2.0.0.255.255 area 0
• D.network 20.1.1.2 255.255.255 area 0

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which command must be applied to R2 for an OSPF neighborship to form?

• A.network 20.1.1.2.0.0.0.0 area 0
• B.network 20.1.1.2 255.255.0.0. area 0
• C.network 20.1.1.2.0.0.255.255 area 0
• D.network 20.1.1.2 255.255.255 area 0

Comment: *

Name: *

Email: *

Verification: *