Refer to the exhibit.

An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)

B)

C)

D)

• A.Option C
• B.Option A
• C.Option B
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

What is the difference between CEF and process switching?

• A.CEF processes packets that are too complex for process switching to manage.
• B.CEF is more CPU-intensive than process switching.
• C.CEF uses the FIB and the adjacency table to make forwarding decisions, whereas process switching punts each packet.
• D.Process switching is faster than CEF.

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

Company policy restricts VLAN 10 to be allowed only on SW1 and SW2. All other VLANs can be on all three switches. An administrator has noticed that VLAN 10 has propagated to SW3.
Which configuration corrects the issue?

• A.SW1(config)#int gi1/1
  SW1(config)#switchport trunk allowed vlan 1-9,11-4094
• B.SW2(config)#int gi1/2
  SW2(config)#switchport trunk allowed vlan 10
• C.SW1(config)#int gi1/1
  SW1(config)#switchport trunk allowed vlan 10
• D.SW2(config)#int gi1/2
  SW2(config)#switchport trunk allowed vlan 1-9,11-4094

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. Which command filters the ERSPAN session packets only to interface GigabitEthernet1?

• A.filter access-group 10
• B.source ip 10.10.10.1
• C.source interface gigabitethernet1 ip 10.10.10.1
• D.destination ip 10.10.10.1

Comment: *

Name: *

Email: *

Verification: *

Reter to the exhibit.

Refer to the exhibit. A network engineer checks connectivity between two routers. The engineer can ping the remote endpoint but cannot see an ARP entry. Why is there no ARP entry?

• A.The ping command must be executed in the global routing table.
• B.When VRFs are used. ARP protocol must be enabled In each VRF.
• C.Interface FastEthernet0/0 Is configured in VRF CUST-A, so the ARP entry is also in that VRF.
• D.When VRFs are used. ARP protocol is disabled in the global routing table.

Comment: *

Name: *

Email: *

Verification: *