Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are mode, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem?

• A.The port channel on SW2 is using an incompatible protocol.
• B.The port-channel trunk is not allowing the native VLAN.
• C.The port-channel should be set to auto.
• D.The port-channel interface lead balance should be set to src-mac

Comment: *

Name: *

Email: *

Verification: *

Which method creates an EEM applet policy that is registered with EEM and runs on demand or manually?

• A.event manager applet ondemand
  event register
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• B.event manager applet ondemand
  event manual
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• C.event manager applet ondemand
  event none
  action 1.0 syslog priority critical msg 'This is a message from ondemand'
• D.event manager applet ondemand
  action 1.0 syslog priority critical msg 'This is a message from ondemand'

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the characteristics from the left onto the correct infrastructure deployment types on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

What is the output of this code?

• A.get_credentials
• B.username
• C.username Cisco
• D.CISCO

Comment: *

Name: *

Email: *

Verification: *

Which behavior can be expected when the HSRP versions is changed from 1 to 2?

• A.No changes occur because the standby router is upgraded before the active router.
• B.Each HSRP group reinitializes because the multicast address has changed.
• C.Each HSRP group reinitializes because the virtual MAC address has changed.
• D.No changes occur because version 1 and 2 use the same virtual MAC OUI.

Comment: *

Name: *

Email: *

Verification: *