FreeQAs
 Request Exam  Contact
  • Home
  • View All Exams
  • New QA's
  • Upload
PRACTICE EXAMS:
  • Oracle
  • Fortinet
  • Juniper
  • Microsoft
  • Cisco
  • Citrix
  • CompTIA
  • VMware
  • ISC
  • SAP
  • EMC
  • PMI
  • HP
  • Salesforce
  • Other
  • Oracle
    Oracle
  • Fortinet
    Fortinet
  • Juniper
    Juniper
  • Microsoft
    Microsoft
  • Cisco
    Cisco
  • Citrix
    Citrix
  • CompTIA
    CompTIA
  • VMware
    VMware
  • ISC
    ISC
  • SAP
    SAP
  • EMC
    EMC
  • PMI
    PMI
  • HP
    HP
  • Salesforce
    Salesforce
  1. Home
  2. Cisco Certification
  3. 350-401 Exam
  4. Cisco.350-401.v2022-12-29.q599 Dumps
  • ««
  • «
  • …
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • …
  • »
  • »»
Download Now

Question 421

Refer to the exhibit.

Which type of antenna do the radiation patterns present?

Correct Answer: B
insert code

Question 422

Refer to the exhibit.

An engineer configures monitoring on SW1 network engineer configures operation. What does the output confirm?

Correct Answer: D
SW1 has been configured with the following commands:
SW1(config)#monitor session 1 source remote vlan 50 SW1(config)#monitor session 2 source interface fa0/14 SW1(config)#monitor session 2 destination interface fa0/15 The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.
Note: In fact we cannot create such a session like session 1 because if we only configure -Source RSPAN VLAN 50 (with the command -monitor session 1 source remote vlan 50) then we will receive a -Type: Remote Source Session (not -Remote Destination Session).
insert code

Question 423

Drag and drop the characteristics from the left onto the infrastructure types on the right.

Correct Answer:

Explanation
insert code

Question 424

Which two pieces of information are necessary to compute SNR? (Choose two.)

Correct Answer: B,D
Signal to Noise Ratio (SNR) is defined as the ratio of the transmitted power from the AP to the ambient (noise floor) energy present. To calculate the SNR value, we add the Signal Value to the Noise Value to get the SNR ratio. A positive value of the SNR ratio is always better.
Here is an example to tie together this information to come up with a very simple RF plan calculator for a single AP and a single client.
+ Access Point Power = 20 dBm
+ 50 foot antenna cable = - 3.35 dB Loss
+ Signal attenuation due to glass wall with metal frame = -6 dB
+ External Access Point Antenna = + 5.5 dBi gain
+ RSSI at WLAN Client = -75 dBm at 100ft from the AP
+ Noise level detected by WLAN Client = -85 dBm at 100ft from the AP
Based on the above, we can calculate the following information.
+ EIRP of the AP at source = 20 - 3.35 + 5.5 = 22.15 dBm
+ Transmit power as signal passes through glass wall = 22.15 - 6 = 16.15 dBm
+ SNR at Client = -75 + -85 = 10 dBm (difference between Signal and Noise) Reference:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Borderless_Networks/Unified_Access/ CMX/CMX_RFFund.html Receive Signal Strength Indicator (RSSI) is a measurement of how well your device can hear a signal from an access point or router. It's a value that is useful for determining if you have enough signal to get a good wireless connection.
EIRP tells you what's the actual transmit power of the antenna in milliwatts.
dBm is an abbreviation for "decibels relative to one milliwatt," where one milliwatt (1 mW) equals
1/1000 of a watt. It follows the same scale as dB. Therefore 0 dBm = 1 mW, 30 dBm = 1 W, and -
20 dBm = 0.01 mW
insert code

Question 425

Refer to the exhibit.

A GRE tunnel has been created between HO and BR routers.
What is the tunnel IP on the HQ router?

Correct Answer: A
Explanation
In the above output, the IP address of "209.165.202.130" is the tunnel source IP while the IP 10.111.1.1 is the tunnel IP address.
An example of configuring GRE tunnel is shown below:
insert code
  • ««
  • «
  • …
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • …
  • »
  • »»
[×]

Download PDF File

Enter your email address to download Cisco.350-401.v2022-12-29.q599 Dumps

Email:

FreeQAs

Our website provides the Largest and the most Latest vendors Certification Exam materials around the world.

Using dumps we provide to Pass the Exam, we has the Valid Dumps with passing guranteed just which you need.

  • DMCA
  • About
  • Contact Us
  • Privacy Policy
  • Terms & Conditions
©2026 FreeQAs

www.freeqas.com materials do not contain actual questions and answers from Cisco's certification exams.