Free Access to Cisco.350-401.v2022-12-29.q599 with Valid Practice Test (Page 87)

Question 426

Refer to the exhibit.

What is required to configure a second export destination for IP address 192.168.10.1?

A.Specify a VRF.
B.Specify a different UDP port.
C.Specify a different flow ID
D.Configure a version 5 flow-export to the same destination.
E.Specify a different TCP port.

Question 427

Refer to the exhibit.

Link1 is a copper connection and Link2 is a fiber connection. The fiber port must be the primary port for all forwarding. The output of the show spanning-tree command on SW2 shows that the fiber port is blocked by spanning tree. An engineer enters the spanning- tree port-priority 32 command on GO/1 on SW2, but the port remains blocked. Which command should be entered on the ports that are connected to Link2 to resolve the issue?

A.Enter spanning-tree port-priority 224 on SW1.
B.Enter spanning-tree port-priority 32 on SW1.
C.Enter spanning-tree port-priority 4 on SW2.
D.Enter spanning-tree port-priority 64 on SW2.

Question 428

What is a requirement for an Ansible-managed node?

A.It must support ad hoc commands
B.It must have an Ansible Tower installed.
C.It must be a Linux server or a Cisco device
D.It must have an SSH server running

Question 429

Refer to the exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue?
A)

B)

C)

D)