Drag and drop characteristics of PIM dense mode from the left to the right.

Correct Answer:

Explanation
A picture containing diagram Description automatically generated

PIM-DM supports only source trees - that is, (S,G) entries-and cannot be used to build a shared distribution tree.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer reconfigures the pot-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log.
Which command set resolves this error?
A)

B)

C)

D)

• A.Option A
• B.Option D
• C.Option B
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Why would a log file contain a * next to the date?

• A.The network device was receiving NTP time when the log messages were recorded
• B.The network device was unable to reach the NTP server when the log messages were recorded.
• C.The network device is not configured to use NTP
• D.The network device is not configured to use NTP time stamps for logging.

Comment: *

Name: *

Email: *

Verification: *

Which two actions, when applied in the LAN network segment, will facilitate Layer 3 CAPWAP discovery for lightweight AP? (Choose two.)

• A.Utilize DHCP option 43.
• B.Configure an ip helper-address on the router interface
• C.Enable port security on the switch port
• D.Configure WLC IP address on LAN switch.
• E.Utilize DHCP option 17.

Comment: *

Name: *

Email: *

Verification: *

What mechanism does PIM use to forward multicast traffic?

• A.PIM sparse mode uses a pull model to deliver multicast traffic.
• B.PIM dense mode uses a pull model to deliver multicast traffic.
• C.PIM sparse mode uses receivers to register with the RP.
• D.PIM sparse mode uses a flood and prune model to deliver multicast traffic.

Comment: *

Name: *

Email: *

Verification: *