An engineer configures a WLAN with fast transition enabled. Some legacy clients fail to connect to this WLAN. Which feature allows the legacy clients to connect while still allowing other clients to use fast transition based on then OUIs?

• A.802.11k
• B.802.11V
• C.over the DS
• D.adaptive R

Comment: *

Name: *

Email: *

Verification: *

Using the EIRP formula, what parameter is subtracted to determine the EIRP value?

• A.transmitter power
• B.antenna cable loss
• C.antenna gain
• D.signal-to-noise ratio

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

R1 has a BGP neighborship with a directly connected router on interface Gi0/0.
Which command set is applied between the iterations of show ip bgp 2.2.2.2?

• A.R1(config)#router bgp 65002
  R1(config-router)#neighbor 192.168.50.2 shutdown
• B.R1(config)#router bgp 65001
  R1(config-router)#neighbor 192.168.50.2 shutdown
• C.R1(config)#ip route 2.2.2.2 255.255.255.255 192.168.50.2
• D.R1(config)#no ip route 192.168.50.2 255.255.255.255 Gi0/0

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the characteristics from the left onto the routing protocols they describe on the right.

Correct Answer:

Explanation

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)

B)

C)

D)

• A.Option D
• B.Option C
• C.Option B
• D.Option A

Comment: *

Name: *

Email: *

Verification: *