Refer to the exhibit:

A network operator working for service provider with an employee id 3715 15:021 applied this configuration to a router.
Which additional step should the engineer use to enable LDP?

• A.Disable Cisco Express Forwarding globally
• B.Delete the static router ID
• C.Enable MPLS LDP on the interface
• D.Configure the both keyword to enable LDP globally

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

Which statement describes this configuration?

• A.Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
• B.Router 1 can be remotely managed by the CLI using Telnet
• C.Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
• D.Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

• A.the hello timers on Router 1 and Router 2 to be different
• B.Router 1 to be an ABR
• C.the area numbers on Router 1 and Router 2 to be similar
• D.the wildcard mask network statement in OSPF of Router 2

Comment: *

Name: *

Email: *

Verification: *

What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

• A.Option A
• B.Option B
• C.Option D
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Company A must increase throughput between two non-IEEE 802.3ad switches located in the access and distribution layers. A network engineer must create a link group with the same speed and duplex. The STP protocol must not block any of the group ports. Which action completes the implementation?

• A.Bundle the physical interfaces with mode lacp configured on each of them.
• B.Enable Port Aggregation Protocol with mode auto under the logical group interface.
• C.Configure a group logical interface with mode active enabled.
• D.Group Ethernet interfaces with mode desirable under the physical interfaces.

Comment: *

Name: *

Email: *

Verification: *