Refer to the exhibit.

An engineer configures FCoE in a newly installed data center. Which configuration must be applied to activate VSAN 100 on VFC100?

• A.Map an FCoE VLAN to VSAN 100.
• B.Allow VSAN 100 on interface eth1/12.
• C.Issue the shutdown Ian command on VFC 100.
• D.Configure a VLAN on VFC 100.

Comment: *

Name: *

Email: *

Verification: *

What occurs when running the command install deactivate <filename> while a software maintenance upgrade is performed on a Cisco Nexus 9000 Series switch?

• A.The current set of packages is committed.
• B.The package is removed from the switch.
• C.The package features for the line card are disabled.
• D.The current upgrade stops.

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the characteristics from the left onto the correct storage systems on the right.

Correct Answer:

Explanation

2,4,5 - NAS 1,3 - SAN

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. What is the result of executing this python code?

• A.It sends the switch configuration to Cisco TAC.
• B.It sends a Cisco device backup to a remote destination.
• C.It schedules a backup on a Cisco switch using EEM.
• D.It backs up Cisco switches to Cisco Prime infrastructure.

Comment: *

Name: *

Email: *

Verification: *

A network engineer must perform a backup and restore of the Cisco Nexus 5000 Series Switch configuration. The backup must be made to an external backup server. The only protocol permitted between the Cisco Nexus switch and the backup server is UDP. The backup must be used when the current working configuration of the switch gets corrupted. Which set of steps must be taken to meet these requirements?

• A.1 Perform a startup-config backup to an FTP server.
  2 Copy startup-config in the boot flash to the running-config file
• B.1 Perform a running-config backup to an SFTP server
  2 Copy backup-config from the SFTP server to the running-config file
• C.1 Perform a running-config backup to an SCP server
  2 Copy running-config in the boot flash to the running-config file
• D.1 Perform a startup-config backup to a TFTP server
  2 Copy backup-config from the backup server to the running-config file

Comment: *

Name: *

Email: *

Verification: *