Refer to the exhibit. The gateway of Server 1 is in the VLAN 100 SVI on N5K-1 and the gateway of Server 2 is in the VLAN 200 SVI on N5K-2. Server 1 must connect to Server 2 using unidirectional traffic. Which action accomplishes this requirement?

• A.Add VLAN 100 and 200 to the allowed VLANs list on the Ethernet 1/1 interface on N5K-1.
• B.Assign VRF WEB membership to interfaces VLAN 150 and 200 on N5K-2.
• C.Configure access VLAN 100 on interface Ethernet 1/2 on N5K-2.
• D.Create a static route in VRF WEB for the subnet of Server 2 on N5K-1.

Comment: *

Name: *

Email: *

Verification: *

An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:
* Named VSAN must be called "VSAN 10".
* VSAN ID must be 10.
* FCoE ID must be 20.
* VSAN 10 must be attached to port 2 in slot 1.

• A.Option C
• B.Option B
• C.Option A
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which two statements describe the routing table of the leaf switch? (Choose two.)

• A.The next hop 10.0.1.14 for route 172.16.99.0/24 is the TEP address of a border leaf in ACI.
• B.The next hop 10.0.8.65 for route 10.20.1.0724 is the TEP address of a border leaf in ACI.
• C.The next hop 10.1.168.95 for route 172.16.100 0/24 is the TEP address of a border leaf in ACI.
• D.172.16.100.0/24 is a BD subnet in ACI.
• E.10.20.1.0/24 is a BD subnet in ACI.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server. Which configuration must be added on the remote OTV AEDs site?

• A.interface Overlay200
  otv join-interface Ethernet1/2
  otv extend-vlan 178, 2500-2563
• B.interface Overlay200
  otv join-interface Ethernet1/2
  otv extend-vlan 178, 2500-2563
  otv use-adjacency-server 20.1.1.1 20.2.1.1 unicast-only
• C.interface Overlay200
  otv join-interface Ethernet1/2
  otv extend-vlan 178, 2500-2563
  otv use-adjacency-server 20.1.1.1 unicast-only
• D.interface Overlay200
  otv join-interface Ethernet1/2
  otv extand-vlan 178, 2500-2563
  otv adjacency-server unicast-only

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?

• A.IPv4 anycast address
• B.IPv4 unicast address
• C.IPv4 multicast address
• D.IPv4 gateway address

Comment: *

Name: *

Email: *

Verification: *