FreeQAs
 Request Exam  Contact
  • Home
  • View All Exams
  • New QA's
  • Upload
PRACTICE EXAMS:
  • Oracle
  • Fortinet
  • Juniper
  • Microsoft
  • Cisco
  • Citrix
  • CompTIA
  • VMware
  • ISC
  • SAP
  • EMC
  • PMI
  • HP
  • Salesforce
  • Other
  • Oracle
    Oracle
  • Fortinet
    Fortinet
  • Juniper
    Juniper
  • Microsoft
    Microsoft
  • Cisco
    Cisco
  • Citrix
    Citrix
  • CompTIA
    CompTIA
  • VMware
    VMware
  • ISC
    ISC
  • SAP
    SAP
  • EMC
    EMC
  • PMI
    PMI
  • HP
    HP
  • Salesforce
    Salesforce
  1. Home
  2. CompTIA Certification
  3. N10-008 Exam
  4. CompTIA.N10-008.v2025-06-03.q684 Dumps
  • ««
  • «
  • …
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • …
  • »
  • »»
Download Now

Question 76

A Fortune 500 firm is deciding On the kind or data center equipment to install given its five-year budget Outlook. The Chief Information comparing equipment based on the life expectancy Of different models. Which Of the following concepts BEST represents this metric?

Correct Answer: B
insert code

Question 77

A user is experiencing network connectivity issues. Upon investigation, the engineer learns that the user installed a personal router and switch to use for multiple computers in the department.
Which of the following has the user most likely introduced into the network?

Correct Answer: C
The user has most likely introduced a rogue DHCP server into the network. Personal routers often come with their own DHCP servers that automatically assign IP addresses to connected devices. If the user's router is not properly configured or is conflicting with the network's primary DHCP server, it can cause IP address conflicts and connectivity issues.
insert code

Question 78

The management team has instituted a 48-hour RTO as part of the disaster recovery plan. Which of the following procedures would meet the policy's requirements?

Correct Answer: C
Reference: https://www.druva.com/blog/understanding-rpo-and-rto/
insert code

Question 79

An administrator is investigating reports of network slowness in a building. While looking at the uplink interface statistics In the switch's CLI, the administrator discovers the uplink Is at 100% utilization However, the administrator is unsure how to Identify what traffic is causing the saturation. Which of the following tools should the administrator utilize to identify the source and destination addresses of the traffic?

Correct Answer: D
To identify the source and destination addresses of the traffic causing network saturation, the network administrator should use a network protocol analyzer that supports the NetFlow protocol. NetFlow is a network protocol that collects IP traffic information as it enters or exits an interface and sends it to a NetFlow collector for analysis. This data includes the source and destination addresses of the traffic, the ports used, and the number of bytes and packets transferred.
Therefore, the correct answer is option D, NetFlow.
Reference: CompTIA Network+ Study Guide, Exam N10-007, Fourth Edition, by Todd Lammle (Chapter 6:
Network Devices)
insert code

Question 80

A network technician is troubleshooting an area where the wireless connection to devices is poor. The technician theorizes that the signal-to-noise ratio in the area is causing the issue. Which of the following should the technician do NEXT?

Correct Answer: D
The signal-to-noise ratio (SNR) is the difference between the received wireless signal and the noise floor, which is the level of background noise on the spectrum. A high SNR means a good signal quality, while a low SNR means a poor signal quality. The noise floor can be affected by various sources of interference, such as cordless phones, microwaves, radar, etc. To troubleshoot a wireless connection issue caused by a low SNR, the technician should first identify and remove any electronics that might be causing interference in the area. This would improve the SNR and the wireless performance. Running diagnostics on the relevant devices, moving the access point to a different location, or escalating the issue to the vendor's support team are possible steps to take after removing the interference sources, but not the next step. References:
* Signal-to-Noise Ratio (SNR) and Wireless Signal Strength
* Wireless: SNR, RSSI and Noise basics of wireless troubleshooting
* What is Signal-to-Noise Ratio and How to Measure it
* Network + N10-008 practice exam
* CompTIA N10-008 Free Certification Exam Material
* Free Practice Questions for CompTIA Network+Exam (N10-008)
insert code
  • ««
  • «
  • …
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • …
  • »
  • »»
[×]

Download PDF File

Enter your email address to download CompTIA.N10-008.v2025-06-03.q684 Dumps

Email:

FreeQAs

Our website provides the Largest and the most Latest vendors Certification Exam materials around the world.

Using dumps we provide to Pass the Exam, we has the Valid Dumps with passing guranteed just which you need.

  • DMCA
  • About
  • Contact Us
  • Privacy Policy
  • Terms & Conditions
©2026 FreeQAs

www.freeqas.com materials do not contain actual questions and answers from Cisco's certification exams.