Which command should a network administrator use to configure a group of interfaces on a Dell EMC N4000 Series switch?

• A.interface range tengigabitethernet 1/0/1, 1/0/8
• B.interface tengigabitethernet 1/0/1-8
• C.interface range tengigabitethernet 1/0/1-8
• D.interface range gigabitethernet 1/0/1-8

Comment: *

Name: *

Email: *

Verification: *

Which commands should a network administrator use to configure a RADIUS server on a Dell EMC N-Series switch?

• A.Switch-1(config)# radius auth server 10.1.1.111
  Switch-1(config-radius)# name
  RADIUS-Server
  Switch-1(config-radius)# key "secretKey"
• B.Switch-1(config)# radius 10.1.1.111
  Switch-1(config-radius)# name RADIUS-Server
  Switch-1(config-radius)# key secretkey
• C.Switch-1(config)# radius server auth 10.1.1.111
  Switch-l(config-radius)# name
  RADIUS-Server
  Switch-1(config-radius)# key "secretkey"
• D.Switch-1(config)# radius auth 10.1.1.111
  Switch-1(config-radius)# name "RADIUS-
  Server" Switch-1(config-radius)# key "secretKey"

Comment: *

Name: *

Email: *

Verification: *

Which type of an attack is considered MAC poisoning?

• A.Duplicating the MAC address of a legitimate device so frames are forwarded to the incorrect port
• B.Host imitating a trunk port by using tagging and trunking protocols
• C.Flooding MAC addresses to the switch to fill its CAM table, causing the switch to act as a hub
• D.Host on a VLAN gaining unauthorized access to other VLANs on the network

Comment: *

Name: *

Email: *

Verification: *

What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?

• A.N-Series switches can be configured to use ISDP or CDP to communicate configuration information with Cisco devices
• B.N-Series switches can be configured to use LLDP or CDP to communicate configuration information with Cisco devices
• C.N-Series switches can be configured to use only CDP to communicate configuration information with Cisco devices
• D.N-Series switches can be configured to use ISDP or LLDP to communicate configuration information with Cisco devices

Comment: *

Name: *

Email: *

Verification: *

Which Dell EMC N-Series switch models can have up to 12 of the same switch model in a stack?

• A.N2000 and N4000
• B.N1100 and N1500
• C.N1500 and N4000
• D.N1500 and N2000

Comment: *

Name: *

Email: *

Verification: *