A BIG-IP Administrator finds the following log entry:
tnm tmm[7141]: 011e0002:4: sweeperjjpdate: aggressive mode activated.
Which action should the BIG-IP Administrator to mitigate this memory issue?

• A.increase the TCP profile ide Timeout value
• B.Configure the redundant par to be active-active
• C.Configure the serve to use Connection Mirroring
• D.Decrease the TCP profile ide Timeout value

Comment: *

Name: *

Email: *

Verification: *

Given that VLAN failElsafe is enabled on the external VLAN and the network that the active BIGIP's external VLAN is connected to has failed, which statement is always true about the results.

• A.The active system will failElover and the standby system will go into active mode.
• B.The active system will reboot and the standby system will go into active mode.
• C.The active system will restart the traffic management module to eliminate the possibility that BIGElIP is the cause for the network failure.
• D.The active system will note the failure in the HA table.

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator needs to restore a UCS file to an F5 device using the Configuration Utility. Which section of the Configuration Utility should the BIG-IP Administrator access to perform this task?

• A.Local Traffic > Policies
• B.Local Traffic > Virtual Servers
• C.System > Configuration
• D.System > Archives

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The BIG-IP Administrator is investigating disk utilization on the BIG-IP device.
What should the BIG-IP Administrator check next?

• A.Large files on the / file system
• B.Results from the EUD test
• C.Large files on /usr file system
• D.Results from the platform diagnostics test

Comment: *

Name: *

Email: *

Verification: *

Which two statements are true concerning the default communication between a redundant pair of BIG-IP systems? (Choose two.)

• A.Synchronization occurs via a TCP connection using ports 683 and 684.
• B.Connection mirroring data is shared through the serial fail over cable unless network failover is enabled.
• C.Connection mirroring data is shared via a TCP connection using port 1028.
• D.Persistence mirroring data is shared via a TCP connection using port 1028.

Comment: *

Name: *

Email: *

Verification: *