A BIG-IP system has the following configuration:
* SNAT is set to Auto Map
* There are two VLANs internal and external
* Default route is pointed to the gateway on external VLAN
* Self P for internal VLAN is 1921.1.2
* Self IP for external VLAN is 192.1.2.2
* Floating IP addresses for internal VLAN is 192.1.1.1
* Floating IP addresses for external VLAN is 192.1.2.1
* The Virtual Server IP address is 192.1.1.100
Which IP address does the BIG-IP system use first when traffic reaches the servers on the internal VLAN?

• A.192.1.2.2
• B.192.1.1.100
• C.192.1.2.1
• D.192.1.1.1

Comment: *

Name: *

Email: *

Verification: *

Which is an advantage of terminating SSL communication at the BIGIP rather than the ultimate web server?

• A.Terminating SSL at the BIG-IP eliminates the need to use SSL acceleration hardware anywhere in the network.
• B.Terminating SSL at the BIG-IP can eliminate SSL processing at the web servers.
• C.Terminating SSL at the BIG-IP eliminates the need to purchase SSL certificates from a certificate authority.
• D.Terminating SSL at IP the eliminates BIG all unencrypted traffic from the internal network.

Comment: *

Name: *

Email: *

Verification: *

Which method is recommended for creating a new user from the CLI?

• A.Run f5adduser username' then 'f5passwd username' from bash or tmsh
• B.Run tmsh create auth user username prompt for password' from bash
• C.edit bigip.conf to add the new user and the user's clear-text password
• D.Run useradd username' then 'passwd username' from bash tmsh

Comment: *

Name: *

Email: *

Verification: *

The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B. Given the virtual server and pool definitions and the statistics shown in the graphic, which member will be used for the next connection?

• A.10.10.20.3:80
• B.10.10.20.1:80
• C.10.10.20.5:80
• D.10.10.20.4:80
• E.10.10.20.2:80

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?

• A.Select Traffic Group and then select Force to Standby
• B.Select Traffic Group and then select Failover
• C.Select Traffic Group on Primary Unit and then select Demote
• D.Create a new Traffic Group and then fail to Standby Unit

Comment: *

Name: *

Email: *

Verification: *