Refer to exhibit, which contains the output of a BGP debug command.

Which statement explains why the state of the 10.200.3.1 peer is Connect?

• A.The local router is receiving BGP keepalives from the remote peer, but the local peer has not received the OpenConfirm yet.
• B.The TCP session to 10.200.3.1 has not completed the 3-way handshake.
• C.The local router is receiving the BGP keepalives from the peer, but it has not received a BGP prefix yet.
• D.The local router has received the BGP prefixes from the remote peer.

Comment: *

Name: *

Email: *

Verification: *

Examine the following partial output from two system debug commands; then answer the question below.


Which of the following statements are true regarding the above outputs? (Choose two.)

• A.The Cached value is always the Active value plus the Inactive value
• B.Kernel indirectly accesses the low memory (LowTotal) through memorypaging
• C.The unit is running a 32-bit FortiOS
• D.The unit is in kernel conserve mode

Comment: *

Name: *

Email: *

Verification: *

The CLI command set intelligent-mode <enable | disable> controls the IPS engine's adaptivescanning behavior. Which of the following statements describes IPS adaptive scanning?

• A.Determines the optimal number of IPS engines required based on system load.
• B.Downloads signatures on demand from FDS based on scanning requirements.
• C.Determines when it is secure enough to stop scanning session traffic.
• D.Choose a matching algorithm based on available memory and the type of inspection being performed.

Comment: *

Name: *

Email: *

Verification: *

Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.
# diagnose debug authd fsso list -FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.
What should the administrator check?

• A.The source IP address of the traffic arriving to the FortiGate from the workstation INTERNAL2. TRAINING. LAB.
• B.The DNS name resolution for the workstation name INTERNAL2. TRAINING. LAB.
• C.The IP address recorded in the logon event for the user STUDENT.
• D.The reserve DNS lookup forthe IP address 192.168.3.1.

Comment: *

Name: *

Email: *

Verification: *

Which statements about bulk configuration changes using FortiManager CLI scripts are correct? (Choose two.)

• A.When executed on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate.
• B.When executed on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate.
• C.When executed on the All FortiGate in ADOM, changes are automatically installed without creating a new revision history.
• D.When executed on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.

Comment: *

Name: *

Email: *

Verification: *