Refer to the exhibit, which contains partial outputs from two routing debug commands.

Why is the port2 default route not in the second command's output?

• A.It has a higher distance than the default route using port1.
• B.It is disabled in the FortiGate configuration.
• C.It has a lowerpriority value than the default route using port1.
• D.It has a higher priority value than the default route using port1.

Comment: *

Name: *

Email: *

Verification: *

View the exhibit, which contains the output of diagnose sys session stat, and then answer the question below.

Which statements are correct regarding the output shown? (Choose two.)

• A.There are 0 ephemeral sessions.
• B.All the sessions in the session table are TCP sessions.
• C.No sessions have been deleted because of memory pages exhaustion.
• D.There are 166 TCP sessions waiting to complete the three-way handshake.

Comment: *

Name: *

Email: *

Verification: *

Which two statements about an auxiliary session are true? (Choose two.)

• A.With the auxiliary session setting enabled, ECMP traffic is accelerated to the NP6 processor.
• B.With the auxiliary session setting enabled, two sessions will be created in case of routing change.
• C.With the auxiliary session setting disabled, for each traffic path, FortiGate will use the same auxiliary session.
• D.With the auxiliary session disabled, only auxiliary sessions will be offloaded.

Comment: *

Name: *

Email: *

Verification: *

The CLI command set intelligent-mode <enable | disable> controls the IPS engine's adaptive scanning behavior. Which of the following statements describes IPS adaptive scanning?

• A.Determines the optimal number of IPS engines required based on system load.
• B.Downloads signatures on demand from FDS based on scanning requirements.
• C.Determines when it is secure enough to stop scanning session traffic.
• D.Choose a matching algorithm based on available memory and the type of inspection being performed.

Comment: *

Name: *

Email: *

Verification: *

Examine the output of the 'get router info ospf neighbor' command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

• A.The interface ToRemote is OSPF network type point-to-point.
• B.The OSPF router with the ID 0.0.0.2 is the designated router for the ToRemote network.
• C.The local FortiGate is the backup designated router for the wan1 network.
• D.The OSPF routers with the IDs 0.0.0.69 and 0.0.0.117 are both designated routers for the wan1 network.

Comment: *

Name: *

Email: *

Verification: *