Examine the output of the 'get router info ospf neighbor' command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.) Refer to the exhibit, which shows the output of a debug command.
Which statement about the output is true?

• A.The OSPF routers with the IDs 0.0.0.69 and 0.0.0.117 are both designated routers for the war. l network.
• B.The interface ToRemote is a point-to-point OSPF network.
• C.The OSPF router with the ID 0.0.0.2 is the designated router for the ToRemote network.
• D.The local FortiGate is the designated router for the wan1 network.

Comment: *

Name: *

Email: *

Verification: *

An administrator is running the following sniffer in a FortiGate: diagnose sniffer packet any "host 10.0.2.10" 2
What information is included in the output of the sniffer? (Choose two.)

• A.IP headers.
• B.Port names.
• C.Ethernet headers.
• D.IP payload.

Comment: *

Name: *

Email: *

Verification: *

A FortiGate is configured as an explicit web proxy. Clients using this web proxy are reposting DNS errors when accessing any website.
The administrator executes the following debug commands and observes that the n-dns-timeout counter is increasing:

What should the administrator check to fix the problem?

• A.The connectivity between the FortiGate unit and the DNS server.
• B.That DNS service is enabled in the explicit web proxy interface.
• C.The connectivity between the client workstations and the DNS server.
• D.That DNS traffic from client workstations is allowed by the explicit web proxy policies.

Comment: *

Name: *

Email: *

Verification: *

Examine the IPsec configuration shown in the exhibit; then answer the question below.

An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands:
diagnose vpn ike log-filter src-addr4 10.0.10.1
diagnose debug application ike -1
diagnose debug enable
The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output .
Why isn't there any output?

• A.The IKE real time debug shows error messages only. If it does not provide any output, it indicates that the tunnel is operating normally.
• B.The IKE real time shows the phases 1 and 2 negotiations only. It does not show any more output once the tunnel is up.
• C.The IKE real time debug shows the phase 1 negotiation only. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1.
• D.The log-filter setting is set incorrectly. The VPN's traffic does not match this filter.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which shows a partial routing table.

Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route? (Choose two.)

• A.Source IPaddress: 10.72.3.52. Destination IP address: 10.1.0.254
• B.Source IP address: 10.1.0.10. Destination IP address: 10.64.1.52
• C.Source IPaddress: 10.10.4.24, Destination IPaddress: 10.72.3.20
• D.Source IPaddress: 10.73.9.10, Destination IPaddress: 10.72.3.15

Comment: *

Name: *

Email: *

Verification: *