View these partial outputs from two routing debug commands:

Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?

• A.port1
• B.port3
• C.port2
• D.Both port1 and port2

Comment: *

Name: *

Email: *

Verification: *

View the exhibit, which contains a partial web filter profile configuration, and then answer the question below.

Which action will FortiGate take if a user attempts to access www.dropbox.com, which is categorized as File Sharing and Storage?

• A.FortiGate will allow the connection based on the FortiGuard category based filter configuration.
• B.FortiGate will exempt the connection based on the Web Content Filter configuration.
• C.FortiGate will block the connection as an invalid URL.
• D.FortiGate will block the connection based on the URL Filter configuration.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.

Which contain the partial configurations of two VPNs on FortiGate.
An administrator has configured two VPNs for two different user groups. Users who are in the Users-2 group are not able to connect to the VPN. After running a diagnostics command, the administrator discovered that FortiGate is not matching the user-2 VPN for members of the Users-2 group.
Which two changes must administrator make to fix the issue? (Choose two.)

• A.Change to aggressive mode on both VPNs.
• B.Enable Mode Config on both VPNs.
• C.Set up specific peer IDs on both VPNs.
• D.Use different pre-shared keys on both VPNs

Comment: *

Name: *

Email: *

Verification: *

Examine the output of the 'diagnose debug rating' command shown in the exhibit; then answer the question below.

Which statement are true regarding the output in the exhibit? (Choose two.)

• A.There are three FortiGuard servers that are not responding to the queries sent by the FortiGate.
• B.The TZ value represents the delta between each FortiGuard server's time zone and the FortiGate's time zone.
• C.FortiGate will send the FortiGuard queries to the server with highest weight.
• D.A server's round trip delay (RTT) is not used to calculate its weight.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

• A.The local FortiGate OSPF router ID is 0.0.0.4.
• B.Port4 is connected to the OSPF backbone area.
• C.The local FortiGate is the backup designated router.
• D.In the network connected to port4, two OSPF routers are down.

Comment: *

Name: *

Email: *

Verification: *