Refer to the exhibit, which shows the output of a BGP summary.

What two conclusions can you draw from this BGP summary? (Choose two.)

• A.External BGP (EBGP) exchanges routing information.
• B.The BGP session with peer 10. 127. 0. 75 is established.
• C.The router 100. 64. 3. 1 has the parameter bfd set to enable.
• D.The neighbors displayed are linked to a local router with the neighbor-range set to a value of 4.

Comment: *

Name: *

Email: *

Verification: *

You want to improve reliability over a lossy IPSec tunnel.
Which combination of IPSec phase 1 parameters should you configure?

• A.fec-ingress and fec-egress
• B.Odpd and dpd-retryinterval
• C.fragmentation and fragmentation-mtu
• D.keepalive and keylive

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which shows a partial routing table.

What two conclusions can you draw from the FortiGate output shown in the exhibit? (Choose two.)

• A.add-route is enabled in the tunnel IPSec phase 1 configuration.
• B.net-device is disabled in the tunnel IPSec phase 1 configuration.
• C.FortiGate is not using the destination subnets of the quick mode selectors to populate the routing table.
• D.FortiGate creates separate virtual interfaces for each VPN client.

Comment: *

Name: *

Email: *

Verification: *

Which two statements about bfd are true? (Choose two)

• A.It can support neighbor only over the next hop in BGP
• B.You can disable it at the protocol level
• C.It works for OSPF and BGP
• D.You must configure n globally only

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which contains a partial configuration of the global system.

What can you conclude from the output?

• A.set strict-d^rty-session-check enable command instructs the FortiGate to offload all dirty session traffic to its SPU
• B.set check-protocol-header loose command enables hardware acceleration on this FortiGate device.
• C.set av-failopen pass command instructs the FortiGate to offload all traffic that uses the antivirus proxy to NP.
• D.set memory-use-threshoId-extreme command instructs the FortiGate to disable hardware acceleration if the memory extreme threshold reaches 95%

Comment: *

Name: *

Email: *

Verification: *