Which of the following descriptions about Route-polic is correct is ______?
Two MSR routers MSR-1 and MSR-2 are interconnected through the 172.16.16.0/20 network segment. Now it is necessary to configure the OSPF protocol on the router MSR-1 to establish the adjacency relationship with MSR-2 normally. Which of the following configurations is not feasible? (Choose one or more) (Choose one or more)
The RIP protocol is enabled on a router, the process number is 1, and the priority is 100; at the same time, the OSPF protocol is enabled, the process number is 100, and the priority is 10.
If these two processes have learned the route of the 10.0.0.0/8 network segment at the same time, and the metric values are 1 (hop count) and 100 (cost value) respectively, then the route 10.0.0.0/8 learned by which process will enter the IP route In the table?
In the OSPF protocol, the destination address used by the DR router to send update messages to all non-DR routers is _____.
In the IS-IS network as shown in the figure, RTB is configured with route aggregation.
So which of the following routes are included in the RTC IS-IS routing table?
