Free Access to H3C.GB0-381-ENU.v2022-05-20.q129 with Valid Practice Test (Page 8)

Question 31

IS-IS routers transfer link status to each other. The information describing the link status is encapsulated in _______.

A.IS-IS dedicated header
B.IS-IS common header
C.Link layer header
D.CLV

Question 32

As shown in the figure, the MSR router in the headquarters is connected to the branch through the Ethernet interface E1/0, and the connection is backed up through the ISDN network. Which of the following options is the most reasonable and feasible at this time?

A.The RIP protocol runs on the Ethernet link between the headquarters and the branch. Set a static route, the outgoing interface is Bri2/0, take the default priority value
B.OSPF protocol runs on the Ethernet link between the headquarters and the branch. Set a static route, the outgoing interface is Bri2/0, and the priority value is 0
C.The RIP protocol runs on the Ethernet link between the headquarters and the branch. Set a static route, the outgoing interface is Bri2/0, and the priority value is 200
D.OSPF protocol runs on the Ethernet link between the headquarters and the branch. Set a static route, the outgoing interface is Bri2/0, and the priority value is 5

Question 33

Regarding filter-polic filtering OSPF routes, which of the following statements are correct?

A.It is not possible to filter routing information through interfaces
B.OSPF routing information can be filtered by the next hop based on the routing information to be added to the routing table
C.It is not possible to filter OSPF routes through the IP address prefix list
D.OSPF routes can be filtered by configuring ACL

Question 34

Among the following OSPF protocol states, those that are not stable are ________.

A.Loading
B.Init
C.2-waC
D.Attempt

Question 35

In H3C equipment, the default priority value of RIP protocol routing is ________.

A.255
B.150
C.10
D.100

Question 31

Question 32

Question 33

Question 34

Question 35

Download PDF File