An architect needs to choose between an Aruba Mobility Controller (MC) 7010 or 7024. Which customer need indicates that the 7024 is a better choice than the 7010?

• A.the need to support PoE+
• B.the need to support 2000 users or devices
• C.the need to connect 20 APs directly to the MC
• D.the need to manage 20 APs

Comment: *

Name: *

Email: *

Verification: *

A Remote AP was properly functioning before losing its internet connection and now cannot communicate with the controller. What SSID is the AP broadcasting?

• A.The SSID in Operational mode Standard and Forwarding mode Tunnel
• B.The SSID in Operational mode Persistent and Forwarding mode Bridge
• C.The SSID in Operational mode Split Tunnel and Forwarding mode Bridge
• D.The SSID in Operational mode Always and Forwarding mode Backup
• E.The SSID in Operational mode Always and Forwarding mode Tunnel

Comment: *

Name: *

Email: *

Verification: *

A customer needs an 802.11ac upgrade for an office with cubicles. The customer states that, because they planned locations for the existing 802.11n APs so that there are no coverage holes, they will simply deploy the new 802.11ac APs in the same location as the existing APs. The customer plans to support mobile devices in addition to laptops.
What should the architect explain about shy a site survey is desirable to determine the optimal locations for the new APs?

• A.An 802ac deployment typically works better with side-mounted, rather than ceiling-mounted, APs, and a site survey will help determine the new mounting locations.
• B.The new 802.11ac deployment should have a capacity-based design for the best performance, but the existing deployment sounds like a coverage-based design.
• C.802.11ac APs can support a higher density of clients, so they can be deployed farther apart than the APs in most existing 802.11n deployments.
• D.802.11ac AP radios tend to be more sensitive to 2.4 GHz interference than 802.11n APs, so the architect needs to search for all potential sources of such interference.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The exhibit shows the current plan for a wired network upgrade.
As much as possible, the customer wants to flatten the architecture and avoid recabling. However, each
Building 2 switch must also maintain connectivity to the core if one link fails. What should the architect
propose to meet the customer requirements?

• A.Combine the switches in each Building 2 closet as a VSF fabric; establish two 10 GbE connections to
  the core per fabric.
• B.Use two additional 2930F switches to act as an aggregation layer for Building 2; connect them to the
  core on 40 GbE connections.
• C.Extend additional fiber between the buildings so that each Building 2 switch can have a direct 10 GbE
  connection to the core.
• D.Connect each Building 2 switch directly to the core on a single fiber strand through the use of SFP+-SR
  transceivers.

Comment: *

Name: *

Email: *

Verification: *

An architect simulates VoIP calls and tests the throughput as 67 Kbps, packet loss as 0.3 percent, maximum latency as 100 ms, and maximum jitter as 100 ms.
Which issue typically causes a poor experience for users?

• A.the latency
• B.the throughput
• C.the jitter
• D.the packet loss

Comment: *

Name: *

Email: *

Verification: *