SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

• A.Option B
• B.Option D
• C.Option A
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Which statement is correct regarding powering an Aruba Access Point?

• A.Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.
• B.Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC power adapter to draw power.
• C.PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.
• D.PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.

Comment: *

Name: *

Email: *

Verification: *

Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)

• A.ISIS
• B.BGP
• C.Local
• D.EIGRP
• E.RIPng

Comment: *

Name: *

Email: *

Verification: *

Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?

• A.Lightweight Access Point Protocol (LWAPP)
• B.Control and Provisioning of Wireless Access Points (CAPWAP)
• C.Generic Routing Encapsulation (GRE)
• D.Process Application Programming Interface (PAPI)

Comment: *

Name: *

Email: *

Verification: *

Which statement is true regarding modern switching requirements?

• A.Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.
• B.While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.
• C.Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.
• D.Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

Comment: *

Name: *

Email: *

Verification: *