You need to create a rule in an HPE Aruba Networking ClearPass Policy Manager (CPPM) role mapping policy that references a ClearPass Device Insight Tag. Which Type (namespace) should you specify for the rule?

• A.Endpoint
• B.TIPS
• C.Device
• D.Application

Comment: *

Name: *

Email: *

Verification: *

You are setting up user-based tunneling (UBT) between access layer AOS-CX switches and AOS-10 gateways. You have selected reserved (local) VLAN mode.
Tunneled devices include IoT devices, which should be assigned to:
* Roles: iot on the switches and iot-wired on the gateways
* VLAN: 64, for which the gateways route traffic.
IoT devices connect to the access layer switches' edge ports, and the access layer switches reach the gateways on their uplinks.
Where must you configure VLAN 64?

• A.In the iot-wired role and on no physical interfaces
• B.In the iot role and the iot-wired role and on no physical interfaces
• C.In the iot-wired role and the access switch uplinks
• D.In the iot role and the access switch uplinks

Comment: *

Name: *

Email: *

Verification: *

All of the switches in the exhibit are AOS-CX switches.
What is the preferred configuration on Switch-2 for preventing rogue OSPF routers in this network?

• A.Disable OSPF entirely on VLANs 10-19.
• B.Configure OSPF authentication on VLANs 10-19 in password mode.
• C.Configure OSPF authentication on Lag 1 in MD5 mode.
• D.Configure passive-interface as the OSPF default and disable OSPF passive on Lag 1.

Comment: *

Name: *

Email: *

Verification: *

You want to examine the applications that a device is using and look for any changes in application usage over several different ranges. In which HPE Aruba Networking solution can you view this information in an easy-to-view format?

• A.HPE Aruba Networking ClearPass OnGuard agent installed on the device
• B.HPE Aruba Networking Central within a device's Live Monitoring page
• C.HPE Aruba Networking ClearPass Insight using an Active Endpoint Security report
• D.HPE Aruba Networking ClearPass Device Insight (CPDI) in the device's network activity

Comment: *

Name: *

Email: *

Verification: *

You are using Wireshark to view packets captured from HPE Aruba Networking infrastructure, but you're not sure that the packets are displaying correctly. In which circumstance does it make sense to configure Wireshark to ignore protection bits with the IV for the 802.11 protocol?

• A.When the traffic was captured on the data plane of an HPE Aruba Networking gateway and sent to a remote IP.
• B.When the traffic was mirrored from an AOS-CX switch port connected to an AP.
• C.When the traffic was captured from an AP with HPE Aruba Networking Central.
• D.When the traffic was captured on the control plane of an HPE Aruba Networking MC and sent to a remote IP.

Comment: *

Name: *

Email: *

Verification: *